Vermont DMV CDL General Knowledge Practice Test 10
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. How do objects appear in a convex mirror compared with a flat mirror?
Show answer
Answer B: Smaller and farther away than they really are, while a wider area is shown
A convex mirror shows a wider field but shrinks everything in it, so the driver must remember that vehicles are closer than they look.
-
2. Your windshield washer reservoir is empty and rain and road spray are expected. What should you do?
Show answer
Answer D: Fill it before the trip, because you need the washers to keep the windshield clear
Wipers alone smear the film of oil and grit thrown up by traffic, so the washers are part of keeping a usable view of the road.
-
3. What does Vermont require of an applicant for a Commercial Learner's Permit?
Show answer
Answer A: Be at least 18 years old and hold a valid Vermont Class D Operator's License
Vermont requires a Commercial Learner's Permit applicant to be at least 18 years old and to already hold a valid Vermont Class D Operator's License.
-
4. Besides the hours when the law requires them, when should headlights be switched on?
Show answer
Answer A: Any time visibility is poor, such as in rain, fog or at dusk
Headlights are used to be seen as much as to see, so they belong on whenever light or weather makes the vehicle harder to spot.
-
5. A 40 foot straight truck and a 70 foot tractor-trailer make the same right turn. Which needs more room and why?
Show answer
Answer B: The tractor-trailer, because the longer the vehicle the farther inside the rear wheels track
Off-tracking grows with the distance between the front and rear axles, so the longer combination cuts the corner much more sharply and needs extra room.
-
6. What frame defects are you looking for during the walkaround?
Show answer
Answer A: Cracks, bends or broken cross members
The frame carries the whole load, so cracked or bent rails and broken cross members are serious structural defects.
-
7. On a wet road, a commercial driver should reduce speed by roughly how much?
Show answer
Answer C: By about one third
Cutting speed by roughly a third, for example from 55 to about 35 mph, restores a margin for the traction lost on a wet surface.
-
8. Does the federal texting ban apply to a company dispatching device mounted in the cab?
Show answer
Answer B: Yes, entering or reading text on it while driving is banned
The rule is written around the act of reading or entering text on any electronic device, not around who owns the device.
-
9. What should you check about the fuel tank during the walkaround?
Show answer
Answer A: That it is securely mounted, the cap is on tight and there are no leaks
A loose tank or a missing cap can spill fuel, and any fuel leak is a fire hazard that makes the vehicle unsafe to drive.
-
10. At the scale your tractor drive axles are overweight while the trailer axles have room. Sliding the trailer tandems forward will do what?
Show answer
Answer C: Move weight off the drive axles and onto the trailer axles
Sliding the trailer tandems forward brings the rear support closer to the load, so the trailer axles pick up more weight and the drive axles carry less; sliding them rearward does the opposite.
-
11. On the Interstate System, what are the federal maximums for a tandem axle group and for gross vehicle weight?
Show answer
Answer B: 34,000 pounds and 80,000 pounds
The federal Interstate limits allow 34,000 pounds on a tandem axle group and 80,000 pounds gross.
-
12. Under federal safety rules, what must the driver of a commercial vehicle do before starting a trip?
Show answer
Answer A: Be satisfied that the vehicle is in safe operating condition
The driver is responsible for inspecting the vehicle and must be satisfied it is in safe operating condition before the trip begins.
-
13. You have a part load that fills only a third of a long trailer. How should it be placed?
Show answer
Answer C: Spread out and centerd side to side, so the weight sits over the axles
A part load is spread over as much of the floor as possible and kept centerd, so no axle is overloaded and the vehicle stays balanced from side to side.
-
14. What does the gross vehicle weight rating of a vehicle describe?
Show answer
Answer A: The maximum loaded weight of that single vehicle, as specified by the manufacturer
The rating is the manufacturer figure for the loaded weight of one vehicle, so it is a limit fixed in advance rather than a measurement of the load on board today.
-
15. Below 40 mph, what following distance does the standard commercial rule of thumb call for?
Show answer
Answer C: One second for every 10 feet of vehicle length
The base rule allows one second of space for each 10 feet of vehicle length while speed stays under 40 mph.
-
16. What does it mean to overdrive your headlights at night?
Show answer
Answer D: Driving so fast that you cannot stop within the distance lit by your headlights
You must be able to stop inside the distance you can see; at night that distance is limited by the headlights, so speed must be lowered to match.
-
17. How are the headlights, marker lights and turn signals checked during the seven-step inspection?
Show answer
Answer A: The engine is shut off, the parking brake is set, the lights are switched on and then checked from outside the vehicle
The lights are switched on with the vehicle secured, then the driver walks around and confirms each lamp actually works and is clean.
-
18. Why must cargo also be held down against vertical movement and not only against sliding?
Show answer
Answer D: Because a load that bounces can jump the blocking and slacken its own tiedowns
Rough road makes an unrestrained article lift; every bounce lets it move a little and works the tiedowns loose until nothing is holding it.
-
19. What information does an inspection decal on a commercial vehicle carry?
Show answer
Answer B: The date of the inspection, where the inspection report is kept, and information identifying the vehicle
The decal shows when the inspection was done, the name and address of the entity that holds the inspection report, and which vehicle it belongs to, so an officer can confirm the inspection at a glance.
-
20. How can a driver restart the 60 or 70 hour on-duty limit?
Show answer
Answer B: Take 34 or more consecutive hours off duty
A period of 34 or more consecutive hours off duty resets the 60 or 70 hour calculation so the driver can begin a new period.
-
21. You have finished a lane change in a vehicle whose turn signal does not cancel by itself. What must you do?
Show answer
Answer D: Turn the signal off yourself
A signal left running tells other drivers you are about to move again, and they may act on that false information.
-
22. What blood alcohol concentration disqualifies the holder of a commercial driver license who is operating a commercial vehicle?
Show answer
Answer D: 0.04 or higher
Commercial drivers are held to 0.04, half the limit that applies to a driver of a passenger car in the same state.
-
23. During a winter closure of the Smugglers Notch segment of Vermont Route 108, which vehicles are prohibited from operating on that segment?
Show answer
Answer A: Single-frame vehicles over 40 feet long and tractor units with trailers over 45 feet in total length
Vermont bans single-frame vehicles over 40 feet and tractor units with attached trailers over 45 feet in total length from the Smugglers Notch segment of Route 108 during a winter closure.
-
24. Your brakes have failed and you decide to use the parking brake to slow down. Why should you hold the release button or lever while doing so?
Show answer
Answer D: So you can release the brake at once if the wheels lock and the vehicle starts to skid
The parking brake can lock the wheels; keeping your hand on the release lets you let go the moment a skid starts and regain control.
-
25. Why should a long vehicle never swing out to the left before starting a right turn?
Show answer
Answer D: Another driver may read it as a left turn or pass on your right
Swinging left opens a gap on your right that a car will move into, and it also sends a false message about which way you are going.
-
26. Why should the mirrors be checked repeatedly while you make a tight turn?
Show answer
Answer C: To watch the rear of the vehicle clear other vehicles and objects
In a long vehicle the rear wheels cut inside the path of the front wheels, so only the mirrors show whether the rear is clearing curbs, poles and other vehicles.
-
27. You are entering a freeway from a short ramp with a fully loaded trailer. What should you do?
Show answer
Answer A: Begin building speed early and wait for a large gap
A loaded vehicle accelerates slowly, so it needs both a running start and a much larger gap than a car would use.
-
28. Experienced commercial drivers scan the road ahead by roughly how much travel time?
Show answer
Answer B: About 12 to 15 seconds
Looking 12 to 15 seconds ahead gives a heavy vehicle enough room to slow or change lanes smoothly instead of reacting late.
-
29. What can repeated violations of the federal phone and texting rules cost a commercial driver?
Show answer
Answer D: Disqualification of the commercial driver license
Multiple convictions for using a hand-held phone or texting while driving a commercial vehicle lead to disqualification, on top of fines for driver and carrier.
-
30. You are loading a flatbed that has no sides or bulkheads. How must the cargo be held?
Show answer
Answer D: By tiedowns, blocking or bracing, since there are no walls to keep it from shifting or falling off
Open decks depend entirely on securement devices; every article must be tied down or otherwise immobilized so it cannot move, spill or fall.
-
31. A fire has started in the vehicle. How should the extinguisher be used?
Show answer
Answer B: Stay as far back as the reach of the extinguisher allows, stand upwind, and aim at the base of the fire
Aiming at the base attacks what is actually burning, and staying upwind and well back protects the driver from heat, smoke and the flames themselves.
-
32. A straight truck has a long body behind the rear axle. What happens to that overhang in a sharp left turn?
Show answer
Answer D: It swings out to the right and can strike a vehicle or an object on that side
Body that hangs behind the rear axle swings the opposite way to the turn, so the tail of the truck sweeps out into the next lane or over the curb.
-
33. Why is a leak in the exhaust system especially dangerous in cold weather?
Show answer
Answer A: Carbon monoxide can build up inside a closed cab
In winter the windows are shut and the heater is running, so exhaust gas that escapes early can reach the driver and cause drowsiness or worse.
-
34. An article of cargo has been blocked so that it cannot move forward. How many tiedowns does the federal rule call for?
Show answer
Answer A: One tiedown for every 10 feet of article length, or any part of that
Blocking against forward movement lowers the requirement to one tiedown per 10 feet of length or fraction of 10 feet.
-
35. You stop to check the load. Which set of things are you looking at?
Show answer
Answer C: Tight tiedowns, cargo that has not moved, secure doors and tarps still fastened
A cargo check covers the load and everything holding it: whether it has shifted, whether the devices are still tight, and whether doors and covers are still closed and fastened.
-
36. What is the minimum tread depth required in every major groove of a steering axle tire?
Show answer
Answer D: 4/32 inch
Federal rules set a higher tread minimum for front steering tires than for other positions because a steering tire failure is far harder to control.
-
37. Why must the driver of a large vehicle keep it centered in its lane?
Show answer
Answer B: The vehicle needs the full width of the lane
A commercial vehicle is close to lane width already, so any drift takes part of the vehicle into the next lane or onto the shoulder.
-
38. Which of these vehicles does the Vermont CDL manual list as exempt from commercial driver's license requirements?
Show answer
Answer A: Motor homes and trailer coaches used for personal recreational purposes
Vermont does not treat motor homes and trailer coaches used for personal recreation as commercial motor vehicles, so their operators are exempt from CDL requirements.
-
39. For a modern truck with low-friction parts and a streamlined shape, which gear should be used going down a grade?
Show answer
Answer D: A gear lower than the one needed to climb the same grade
Newer trucks roll more freely than older ones, so the old rule of using the climbing gear no longer holds; a lower gear is needed for enough engine braking.
-
40. You are given a ratchet strap with a deep cut along one edge. What should you do?
Show answer
Answer C: Do not use it; a damaged tiedown cannot be relied on to hold its rated load
Cuts, burns, knots and broken stitching weaken a strap far below its marked working load limit, so it must be taken out of service.
-
41. What speed and gear should be used when backing a large vehicle?
Show answer
Answer B: As slowly as possible, in the lowest reverse gear
Backing slowly in the lowest reverse gear keeps the vehicle under precise control and leaves time to correct the path.
-
42. Who is generally prohibited from plowing or depositing snow onto the traveled way of a Vermont State highway or a class 1, 2, or 3 town highway?
Show answer
Answer C: Anyone other than an employee performing official duties or a person authorized by the Agency of Transportation or the selectboard
Vermont bars anyone other than an employee performing official duties, or a person authorized by the Agency of Transportation or a town selectboard, from plowing or depositing snow onto the traveled way, shoulder, or sidewalk of a covered highway.
-
43. What is the coupling device weight rating on a vehicle?
Show answer
Answer A: The most weight that the coupling on the vehicle is rated to pull
The coupling device rating is a limit on how much weight the coupling may tow, and it is one of the ratings that has to be respected when a combination is loaded.
-
44. An oncoming vehicle at night has bright headlights that are making it hard to see. What should you do?
Show answer
Answer B: Look toward the right edge of your lane and avoid looking directly at the lights
Looking at the right edge of the road keeps your eyes off the glare while you stay in your lane; glare can leave you nearly blind for several seconds.
-
45. On packed snow, how much should a commercial driver reduce speed?
Show answer
Answer D: By about one half or more
Packed snow costs far more traction than rain, so speed should be cut by half or more.
-
46. What should be checked about the power steering system in the engine compartment?
Show answer
Answer D: That the fluid level is correct and the hoses and pump are not leaking
Losing power steering fluid means losing steering assistance, which can happen suddenly and makes a heavy vehicle very hard to turn.
-
47. How does overloading affect the way a vehicle drives?
Show answer
Answer C: It slows the vehicle on upgrades, makes stopping take longer and can overheat the brakes on downgrades
Extra weight demands more from the engine and the brakes, so the vehicle climbs slowly and needs much more distance to stop.
-
48. Why is a sudden, sharp lane change dangerous in a loaded heavy vehicle?
Show answer
Answer D: The vehicle can lean far enough to roll over, especially when the load sits high
A quick swerve throws the weight of a tall, heavy load sideways, and a rollover can begin before the tires ever slide.
-
49. After two hours of driving you measure a tire and the pressure reads higher than the cold figure. What should you do?
Show answer
Answer B: Nothing, because pressure rises normally as a tire heats up in use
Air expands as the tire heats, so a higher hot reading is expected, and letting air out leaves the tire underinflated once it cools.
-
50. What does the driver check in the final step of the seven-step inspection?
Show answer
Answer A: Hydraulic brake leaks where those brakes are fitted, then the parking brake and the service brakes
The last step is done with the engine started: test for hydraulic leaks on vehicles with hydraulic brakes, then prove that the parking brake holds and that the service brakes stop the vehicle.