Vermont DMV CDL warm-up test

  • Questions50
  • Correct to pass40
  • Passing score80%
  • Minimum age18 years

10 questions. Pick an answer to see if it is right and why; you need 8 correct answers to pass.

  1. 1. What does the federal bridge formula do?

    Show answer

    Answer C: It reduces the weight allowed on a group of axles as those axles get closer together

    Axles bunched together concentrate the load on a short span of a bridge, so the formula lowers the allowable weight as the spacing shrinks.

  2. 2. You find a defect during the pre-trip inspection. What must happen before the vehicle is driven?

    Show answer

    Answer C: It must be repaired, or the vehicle must not be driven

    Writing a defect down does not make the vehicle safe; a defect that affects safe operation has to be corrected before the trip starts.

  3. 3. When is tire pressure most accurately compared with the recommended figure?

    Show answer

    Answer B: When the tires are cold, before the vehicle has been driven

    Recommended pressures are cold pressures, so a reading taken before the tires have heated up is the only one that can be compared directly.

  4. 4. What should you look for on the electrical wiring in the engine compartment?

    Show answer

    Answer A: Worn, frayed or cracked insulation and loose or corroded connections

    Damaged insulation can short a circuit against the frame or engine, which can kill a lamp you depend on or start a fire.

  5. 5. When must a post-trip inspection be made?

    Show answer

    Answer D: At the end of each day the driver operates the vehicle

    The post-trip inspection closes out each driving day so that anything found is recorded before the vehicle is handed to the next driver.

  6. 6. When should a lower gear be selected for a long downgrade?

    Show answer

    Answer D: Before you start down the hill

    The gear is chosen at the top, while speed is still low, because a heavy vehicle already rolling fast may not go into a lower gear at all.

  7. 7. Why is a quick lane change particularly risky with a load of hanging meat or of livestock?

    Show answer

    Answer A: The load swings or leans and can keep pushing the trailer after you straighten out

    A swinging or leaning load keeps moving after the vehicle has finished the maneuver, so its momentum acts on the trailer at the worst moment.

  8. 8. A driver is tailgating you, honking and making gestures. What is the best response?

    Show answer

    Answer A: Do not make eye contact, ignore the gestures and give the driver room to get past

    Engaging an aggressive driver only escalates the situation; the safest move is to stay calm, avoid eye contact and let the driver get by.

  9. 9. You are dropping a loaded trailer in a yard. How far should the landing gear be lowered?

    Show answer

    Answer A: Until the pads make firm contact and the trailer weight is just off the fifth wheel

    Cranking down until the gear is firmly on the ground and just lifting the load off the fifth wheel makes the trailer stable and lets the tractor pull out cleanly.

  10. 10. Which windshield condition should be reported during the inspection?

    Show answer

    Answer B: Cracks or dirt that get in the way of your view of the road

    The windshield must give a clear view; damage or grime in the driver line of sight is a safety defect.